Replacing Hot Water Heater Anode

Replacing Hot Water Heater Anode

Replacing Hot Water Heater Anode

How to Replace a Water Heater Anode Rod. Richmond, Marathon, Eclipse, Vanguard, Hotpoint and General.
Full episode: https://www.youtube.com/watch?vU6tCXDsciok This Old House plumbing and heating.
Open a hot water faucet in the house or flip the relief valve open on the water heater. Open the drain valve.
How to replace the anode rod in your hot water heater.Do you have stinky water. Chance are if you replace.
Method 2. Avoiding draining the tank. Turn off the gas or electricity supply. Turn off the water supply to the tank. Open the drain at the bottom of the tank. It would be helpful to spray some lubricant such as WD-40 around the hex head of the rod, then let it penetrate a few minutes before trying to loosen the rod.
Even with a breaker bar, it can be nearly impossible to break the anode rod free. Turn off the power or gas. Then close the cold-water valve at the top of the tank and drain off several gallons. Loosen the hex head with the impact wrench, but unscrew it the rest of the way by hand.
On most it will look like a hexagonal plug screwed into the heater. Some heaters have the anode attached to the hot water outlet port and appear to be a pipe .
In this how-to video, This Old House plumbing and heating contractor Richard Trethewey shows a simple way to add years to your water heater.
Your hot water system may be about to rupture or rust through and the. double the life of your HOT WATER.
The hot water heater comes about as close to being maintenance-free as any household appliance. Once it is properly installed and set to the right temperature , .

1 Related Images of Replacing Hot Water Heater Anode

Leave a Reply

Your email address will not be published. Required fields are marked *